Creality Ender 5 PLUS Silent Board Upgrade
Upgraded Silent Board with TMC2208 Driver For Creality Ender 5 PLUS Printer
This option is the separate upgraded for Ender 5 PLUS, just plug it in and you could start printing.
Notice: This new upgraded silent mainboard does not currently come pre-installed on Ender 5 PLUS.
-Super Quiet and Noise Reduction. Use TMC2208 Stepper Motor Drivers, which the key component to eliminate the printer's motor when printing.
-Bootloader pre-installed. The firmware can be modified by ARDUINO or Cura with the USB cable.
-Concern for safety. Thermal runaway protection is enabled, if the temperature rises out of control, the printer will stop heating and halt automatically.
- Stepper Motor Driver based on TMC2208
- Voltage: Works on 12V and 24V
- Can Work For CR-10S5.<You need to flash the firmware then you could use it> Firmware Download
Creality V2.2 PCB:
Different from Regular V2.2 Board, in the position of stepper motor driver chip, the resistance value is different (can be directly observed on the motherboard).
Conventional: R100 mute: R150